Mercurial > prosody-modules
view mod_secure_interfaces/README.markdown @ 5173:460f78654864
mod_muc_rtbl: also filter messages
This was a bit tricky because we don't want to run the JIDs
through SHA256 on each message. Took a while to come up with this
simple plan of just caching the SHA256 of the JIDs on the
occupants.
This will leave some dirt in the occupants after unloading the
module, but that should be ok; once they cycle the room, the
hashes will be gone.
This is direly needed, otherwise, there is a tight race between
the moderation activities and the actors joining the room.
author | Jonas Schäfer <jonas@wielicki.name> |
---|---|
date | Tue, 21 Feb 2023 21:37:27 +0100 |
parents | 4d73a1a6ba68 |
children |
line wrap: on
line source
--- labels: - 'Stage-Beta' summary: 'Mark some network interfaces (e.g. loopback/LAN) as always secure' ... Introduction ============ Sometimes you might run clients without encryption on the same machine or LAN as Prosody - and you want Prosody to treat them as secure (e.g. allowing plaintext authentication) even though they are not encrypted. This module allows you to tell Prosody which of the current server's interfaces (IP addresses) that you consider to be on secure networks. Configuration ============= Configuration is simple, just load the module like any other by adding it to your modules\_enabled list: modules_enabled = { ... "secure_interfaces"; ... } Then set the list of secure interfaces (just make sure it is set in the global section of your config file, and **not** under a VirtualHost or Component): secure_interfaces = { "127.0.0.1", "::1", "192.168.1.54" } Compatibility ============= ------- --------- 0.9 Works 0.8 Unknown trunk Works ------- ---------