view mod_auth_external.wiki @ 369:1861f3e1e9ff

mod_auth_ccert: Add page
author Kim Alvefur <zash@zash.se>
date Fri, 28 Jun 2013 18:21:37 +0200
parents 35702f67785f
children 5720e3f68061
line wrap: on
line source

#summary Authentication via external script/process
#labels Stage-Alpha,Type-Auth

= Introduction =

Allow client authentication to be handled by an external script/process.

= Configuration =

As with all auth modules, there is no need to add this to modules_enabled. Simply add in the global section, or for the relevant hosts:

{{{
    authentication = "external"
}}}

These options are specific to mod_auth_external:

||external_auth_protocol||May be "generic" or "ejabberd" (the latter for compatibility with ejabberd external auth scripts. Default is "generic".||
||external_auth_command||The command/script to execute.||

= Protocol =

Prosody executes the given command/script, and sends it queries.

Your auth script should simply read a line from standard input, and write the result to standard output.
It must do this in a loop, until there's nothing left to read. Prosody can keep sending more lines to the script,
with a command on each line.

Each command is one line, and the response is expected to be a single line containing "0" for failure or "1" for success.
Your script must respond with "0" for anything it doesn't understand.

There are three commands used at the moment:

== auth ==
Check if a user's password is valid.

Example: {{{auth:username:example.com:abc123}}}

Note: The password can contain colons. Make sure to handle that.

== isuser ==
Check if a user exists.

Example: {{{isuser:username:example.com}}}

== setpass ==
Set a new password for the user. Implementing this is optional.

Example: {{{setpass:username:example.com:abc123}}}

Note: The password can contain colons. Make sure to handle that.

== ejabberd compatibilty ==
ejabberd implements a similar protocol. The main difference is that Prosody's protocol is line-based, while ejabberd's is length-prefixed.

Add this to your config if you need to use an ejabberd auth script:
{{{
	external_auth_protocol = "ejabberd"
}}}

= Compatibility =
||0.8||Works||